Change start and end locations for drivers

By default, your drivers will start and end their routes at your depot. However, sometimes you need drivers to start and end at locations that aren't your primary depot, like their homes. You can also use this if you have multiple secondary depots where drivers normally start from. In this article, we will show you how to set this up. 

Who can use this feature
	All plans
	Users that have administrator privileges
	All regions

Change start and end location for individual drivers

To change the start and end location for individual drivers: 

1. Go to Administration→Drivers from the top menu
2. Double click on the driver you want to modify
3. On the left side of the driver window, select "Start location"
4. Uncheck the "Use depot as start location"
5. Choose the address you want them to start from
6. Repeat for "End location"
7. Click "Save"

This driver will now be routed to/from these locations. 

Tip: You can also end your route on the last stop instead of ending at a specific location.

Change start and end location for multiple drivers

You can also perform this action in bulk if many drivers start and end at the same locations. 

To change start and end location in bulk: 

1. Go to Administration→Drivers from the top menu
2. Select the drivers you want to modify 
3. Click "Edit drivers" at the top of the table
4. On the left side of the driver window, select "Start location"
5. Choose the option for a "Custom location"
6. Choose the address you want them to start from
7. Repeat for "End location" if you want to
8. Click "Save"

These drivers will now be routed to/from these locations.

Tip: You can bulk change start and end locations to accommodate multiple depots.